LNGIII metrology workshop

LNGIII metrology workshop and training

Corona-Update (March 25th): Due to travel restrictions, government regulations and the temporary closing of the Ruhr-University (each until at least April 19th) as well as the uncertainty about the further development of the pandemic, the LNG III metrology workshop will be held completely in a virtual meeting. Hence, no physical presence in Bochum is required.

The workshop will continue to take place on 28 and 29 May (UTC+01:00). The program stated below may be slightly modified to better fit a remote conference.

LNG metrology workshop 28. May 2020

09:00 – 09:15 LNGIII “Metrological support for LNG and LBG as transport fuel” project overview

09:15 – 10:00
LNGIII WP1 highlights
9:15 – 09:30 Asaad Kenbar, NEL, “Systematic assessment of LNG flow meter uncertainty- highlights”
09:30 – 09:45 Rémy Maury, Cesame, “Development of a cryogenic LDV standard- highlights”
09:45 – 10:00 Kianoosh Hadidi, JV, “Uncertainty analysis of the LNG flow measurement and the measurement models”

10:00 – 10:45 LNGIII WP2 highlights
10:00 – 10:15 Liquefier metrological validation highlights
10:15 – 10:30 Cryogenic density measurements highlights
10:30 – 10:45 LNG particulate measurements highlights

10:45 – 11:00 Break

11:00 – 11:45 LNGIII WP3 highlights
11:00 – 11:45 Arjen Boersma, TNO, “Comparing the ECC, TFIR, FTIR Methane Number sensors”

11:45 – 12:30 LNGIII WP4 highlights
11:45 – 12:30 “Determination of the Methane Number from Reaction Kinetics to Engine Tests”

12:30 – 13:30 Lunch

13:30 – 14:15 Q&A session advisory board and consortium. 
13:30 – 14:15 Hosted by Dorus Bertels chairman of the LNGIII Advisory Board

14:15 – 14:30 Break

14:30 – 15:00   Martijn van Essen DNVGL
14:30 – 15:00 “PKI Methane number”

15:00 – 15:30 Bas van den Beemt HSH
15:00 – 15:30 “Marine LNG Custody Transfer measurement for small scale LNG transfer and bunkering”

 

LNG metrology training 29. May 2020

09:00 – 11:00 LNGIII WP2 Traceable LNG density measurement and calculation training

11:00 – 12:30 LNGIII WP1 session
11:00 – 11:30 Menne Schakel, VSL, NEL “Calibration of Industry-Standard LNG Flow Meters Under Ambient and Cryogenic Test Conditions”
11:30 – 12:00 Rémy Maury, Cesame, “Validation of cryogenic LDV standard by comparison with cryogenic mass flow meters”
12:00 – 12:30 Andrew Hunt, Atout, “Development of high speed ECT sensor for cryogenic measurements”

12:30 – 13:30 Lunch

13:30 – 16:15 LNGIII combined WP3 & WP4 session
13:30 – 14:00 VTT LNGIII research and outcomes
14:00 – 14:30 TUBS “Experimental and Theoretical Determination of the Service Methane Number”
14:30 – 15:00 PTB “Correlation between the MN and the ignition delays and the chemical kinetics analysis of the LNG gases”

15:00 – 15:15 Break

15:15 – 15:45 Andrés Pérez Quiroga, Reganosa, Mestrelab, Naturgy, UDC “A fast MN determination using the IR spectrum of a NG fuel”
15:45 – 16:15 TNO “In-line ECC gas composition sensor and it’s use on a dual-fuel truck engine”

Note: CET time applies